Kwik-Fit Ensemble Bedhead Bracket Set (STANDARD)

Quality Kwik-Fit Ensemble Bedhead Bracket Set (STANDARD) Sydney, Australia
In stock
Only %1 left
Standard Bed Bracket Set designed to attach your bedhead to your ensemble base. For larger/heavier bedheads, it is recommended to use our Kwik-Fit ""Premium"" Ensemble Bed Bracket Set (250mm)

What is in the bracket kit?

  • 2x bed brackets
  • 4x screws
  • 4x 8mm diameter bolts
  • 4x washers
  • 4x nuts

How do I put it together?

  1. Turn ensemble base onto side and unscrew two end castors.
  2. Hold brackets against bed and refit the castor through the slot in the bracket temporarily.
  3. Place ensemble base into the normal position on the floor to establish position of bracket in relation to bedhead. Make small markings in pencil where drill holes will be required for mounting.
  4. Remove castor and bracket from ensemble to now mount bracket to bedhead.
  5. Drill two holes in bedhead where you had marked out previously. Screw 2x bolts with washers on each bracket with nuts on reverse to securely hold bedhead in place. Tighten till firm.
(PLEASE NOTE: As bedheads can vary in thickness, the bolts supplied may not be the correct length. Different length bolts are available from your local hardware store.)
  1. You can now refit the castor back through the bracket into the base. For extra support, screw 2x screws into each bracket’s drill holes.
  2. Enjoy a good night’s sleep after successfully fitting your bedhead to ensemble.

Pack Sizes Available:

  • Each - Single Bed Set
  • Box of 10x Bed Sets